Ellipsoid (datum)Įllipsoids describe the shape of the earth used to calculate the UTM grid. In the region around Svalbard, the four grid zones 31X (9° of longitude in width), 33X (12° of longitude in width), 35X (12° of longitude in width), and 37X (9° of longitude in width) are extended to cover what would otherwise have been covered by the seven grid zones 31X to 37X.Īll exceptions are considered. On the southwest coast of Norway, grid zone 32V (9° of longitude in width) is extended further west, and grid zone 31V (3° of longitude in width) is correspondingly shrunk to cover only open water. Each latitude band is 8° high, and is lettered from "C" to "X", omitting the letters "I" and "O". Converting from lat/lon-> utm -> lat/lon returns the same latitude and longitude within 6 or 7 decimal places, which is probably more accurate than coordinates. When the coordinates are converted, the result. Then just click 'Convert' and wait for the conversion result. Next, select the desired format to which your coordinates will be converted. Then enter latitude and longitude in the corresponding fields in the 'Convert Coordinates' section. Enter the GPS Latitude/Longitude coordinate (decimal degrees). First, select the 'Convert Coordinates' mode of operation. You can enter latitude and longitude data. The length is given in -180° to +180° East, instead of 180° West to 180° East. On this page the latitude is given in decimal degrees from -90° to +90°, it would also be possible to give from 90° south to 90° north. Latitude bandĮach zone is segmented into 20 latitude bands. UTM Converter is a geographic tool for converting UTM (Universal Transverse Mercator) coordinates. This app allows you to convert between UTM and Geographic coordinates. Geographic coordinates (WGS84) The geographical coordinates describe a point by its angular distance from the equator. The UTM system divides the Earth into 60 zones, each 6° of longitude in width. The zone is always written first, followed by the latitude band. Follows the UTM coordinates and divides the world into 6-degree longitude and 20 latitude bands, but MGRS then further subdivides the grid zones into smaller. The combination of a zone and a latitude band defines a grid zone. The system instead divides the Earth into sixty zones, each a six-degree band of longitude, and uses a secant transverse Mercator projection in each zone. The UTM system is not a single map projection. it is used to identify locations on the Earth independently of vertical position, but differs from the traditional method of latitude and longitude in several respects. It is a horizontal position representation, i.e. UTM is conformal projection uses a 2-dimensional Cartesian coordinate system to give locations on the surface of the Earth. Latitude longitude to UTM Universal Transverse Mercator (UTM)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |